Fnetclonedriveserialnumber
Download File - https://tlniurl.com/2tzxvf
How to Change FNet Clone Drive Serial Number
FNet Clone Drive is a software that allows you to clone your hard drive or partition to another drive or partition. It is useful for backup, recovery, migration, or upgrading purposes. However, sometimes you may encounter a problem when you try to activate Windows or other software on the cloned drive. This is because the cloned drive has the same serial number as the original drive, which may cause a conflict or a violation of the license agreement.
Fortunately, there is a way to change the FNet Clone Drive serial number and avoid this issue. In this article, we will show you how to do it in a few simple steps.
Step 1: Download and Install FNet Clone Drive
If you don't have FNet Clone Drive installed on your computer, you can download it from the official website. The software is compatible with Windows XP, Vista, 7, 8, 8.1, and 10. It supports FAT16, FAT32, NTFS, and exFAT file systems. It also supports IDE, SATA, SCSI, USB, Firewire, and RAID drives.
After downloading the setup file, run it and follow the instructions to install FNet Clone Drive on your computer. You may need to restart your computer after the installation.
Step 2: Launch FNet Clone Drive and Select the Source and Target Drives
Launch FNet Clone Drive from the Start menu or the desktop shortcut. You will see the main interface of the software. Here you can select the source drive (the original drive that you want to clone) and the target drive (the new drive that you want to clone to). You can also adjust the partition size and alignment of the target drive if needed.
Make sure that both the source and target drives are connected to your computer and recognized by FNet Clone Drive. If not, you may need to check the cables, ports, or drivers of your drives.
Step 3: Start Cloning and Wait for the Process to Complete
After selecting the source and target drives, click on the \"Start\" button at the bottom right corner of the interface. FNet Clone Drive will start cloning your drive and show you the progress and status of the process. Depending on the size and speed of your drives, this may take some time.
Do not interrupt or shut down your computer during the cloning process. This may cause data loss or damage to your drives. Wait until FNet Clone Drive finishes cloning your drive and shows you a message that says \"Clone Completed\".
Step 4: Change FNet Clone Drive Serial Number
Now that you have cloned your drive successfully, you need to change the FNet Clone Drive serial number of the target drive. This will prevent any activation or license issues with Windows or other software on the cloned drive.
To change the FNet Clone Drive serial number, you need to use a tool called VolumeID. This is a free utility that allows you to change the volume ID (also known as serial number) of any disk drive in Windows.
Download VolumeID from this link and unzip it to a folder on your computer. Then run VolumeID.exe as administrator. You will see a command-line window with some instructions.
Type in the following command:
volumeid : xxxx-xxxx
Replace with the letter of your target drive (for example, D:). Replace xxxx-xxxx with any combination of four hexadecimal digits (for example, 1234-5678). This will be your new FNet Clone Drive serial number.
Press Enter to execute the command. You will see a message that says \"Volume ID of drive : updated successfully.\"
Congratulations! You have changed the FNet Clone Drive serial number of your target drive. You can now activate Windows or other software on your cloned drive without any problems. 061ffe29dd